AnyDesk

About AnyDesk

AnyDesk exists because most remote desktop tools fall apart on a connection that is not a local network. The codec it uses is built around interactive frames rather than video, so a cursor moving across a desktop stays ahead of the eye at bandwidth levels where other tools turn into a slideshow. On a stable line the session feels close enough to local that people forget which machine they are typing on.

Getting connected is short. Each installation carries an address, and typing the other side's address opens a request that the remote user accepts. For machines that nobody sits at, unattended access sets a fixed password on the remote end so a session opens without anyone present, which is the mode most people end up using for a render box or a machine in another room.

The session itself carries more than a picture. Files copy in both directions by dragging them into the window or through a paired file manager panel, the clipboard is shared including file contents, and audio from the remote machine can be routed back. Sessions can be recorded to a local file, which is worth turning on when the point of the connection is to document what a machine was doing.

The permission model is per session and reasonably granular. Input control, clipboard access, file transfer, audio and the ability to lock the remote desktop are all separate toggles, and an access control list restricts which addresses may connect at all. A whiteboard layer draws over the shared screen for pointing at things without taking control.

What is included in this build

• Low latency remote desktop that stays interactive on poor connections
• Unattended access with a fixed password for machines nobody sits at
• Bidirectional file transfer by drag and drop or through a paired file manager
• Shared clipboard including file contents rather than text only
• Remote audio routed back to the local machine
• Session recording written to a local file for later review
• Per session permission toggles for input, clipboard, transfer and audio
• Address based access control list restricting who may connect at all

Changed in version 9.7.14

• Improved frame pacing on connections with high jitter
• Faster file transfer throughput on large directory trees
• Multi-monitor selection reworked for machines with mixed resolutions
• Reduced memory use during long running sessions
• Additional interface language corrections

Installation walkthrough

These steps assume a clean machine. If a previous release of the same application is present, deal with that first, since an overlapping install is the most common cause of a setup that stops halfway.

1. Close any other remote access tool before starting, since display hooks can conflict.
2. Extract the archive to any folder and run the installer as administrator.
3. Allow the display driver component to register when setup prompts for it.
4. Set an unattended access password immediately if the machine will be reached without anyone present.
5. Restrict the access control list to known addresses before leaving the machine running.

System requirements and file details

Frequently asked about this title